cartel

thats why im asking you lol..

pm me a price shipped to 98264 --

Bob@BruteSpeed

iTrader: (16)

PM has been sent. Thanks. Bob

SS MPSTR

iTrader: (1)

Can you PM me a price shipped to 92399? Thanks.

StealthSierra

iTrader: (1)

PM me a set shipped to 77377 please.

Bob@BruteSpeed

iTrader: (16)

PM sent, thanks! Bob

Bob@BruteSpeed

iTrader: (16)

Special LS1 discount on these headers! Bob

Bob@BruteSpeed

iTrader: (16)

http://shop.brutespeed.com/Kooks-645...450-S-0711.htm
I still have four sets left at this deep discount! Bob

BanditDave

iTrader: (11)

Bob,

Shoot me a priced shipped for the Abodies 1 7/8" to 08065, please. Eager to see if they work with the Edelbrock mounts and the AutoKraft Pan...decent size kick outs on that things.

Gotta let it breathe for the Procharger I'm gonna order from you...actually I will need two of them, but I digress...lol

Thanks,
Dave

Bob@BruteSpeed

iTrader: (16)

FREE SHIPPING! We have four sets in stock as of 9/22/12

See options at the bottom of the link for LS1tech member discounts. Thanks Dave. Bob
http://shop.brutespeed.com/Kooks-645...450-S-0711.htm

01cherryreds10

iTrader: (9)

Hey Bob any idea if these will fit G-bodies? If they do I highly doubt they will last much longer on this site

Bob@BruteSpeed

iTrader: (16)

1977 T/A

I use to race a '79 and '80 Malibu's, so I know the chassis pretty well. Off hand I don't see why these headers would not work. Bob

Doug G

Bob/Jon....I have an issue with plug wires and that cross over pipe....What did you guys do to address this issue ???

Thanks.

Bob@BruteSpeed

iTrader: (16)

We don't have the engine built yet for the '77 T/A, but it seems that 90 degree boots on the plug wires would work. Have you tried that? Bob

wildcamaro

iTrader: (15)

Man I wish someone made a set of second gen fbody headers that could accommodate a manual clutch linkage! I had to use manifolds and modify the zbar a lot!

zamora7

iTrader: (4)

Any idea if these fit with 1 inch setback plates from carshop inc? Can you pm me a price as well please.

Bob@BruteSpeed

iTrader: (16)

Do these look like they have a chance of working? Bob

Bob@BruteSpeed

iTrader: (16)

I am not sure if they will clear the Carshop adapter plates.



See options at the bottom of the link for LS1tech member discounts. Thanks. Bob
http://shop.brutespeed.com/Kooks-645...450-S-0711.htm

BanditDave

iTrader: (11)

Bob, shot you a PM...didn't want to clutter up the thread.

wildcamaro

iTrader: (15)

They might work since pipe # 7 is so far forward....does the collector face straight down like block hugger type? That's my problem that the collector on the fbody manifold ended right above the z-bar link that's has the pushrod that goes to the clutch fork...I'd like to see a pic of the whole header....thanks!

Bob@BruteSpeed

iTrader: (16)

Go to the link I posted above, I have quite a few pic's of the headers. Thanks. Bob