1980 Malibu My new project
#21
10 Second Club
Thread Starter
iTrader: (19)
Join Date: Nov 2003
Location: STL
Posts: 3,494
Likes: 0
Received 0 Likes
on
0 Posts
Spent a few more hours last night and got the things not needed unpinned from the PCM. Can't go much further until i get a motor and everything in the car and i'll short and lengthen what I need.
#24
10 Second Club
Thread Starter
iTrader: (19)
Join Date: Nov 2003
Location: STL
Posts: 3,494
Likes: 0
Received 0 Likes
on
0 Posts
Sorry no updates been waiting on parts for a couple weeks now but some stuff should show up tomorrow.
#34
TECH Apprentice
iTrader: (12)
Join Date: Feb 2008
Location: newark, ohio
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
Yea Vette ran 10.62 this car should be a good amount faster when all done.
I look at this way if i could get my old 4,000lb G8 to trap 134+ what could I get this car to trap with the same power as the G8 and even lighter than the C6
I'm going to do as much as i can to get it down a good amount.
Plan is fiberglass front and rear bumpers that will drop 70-80lbs car already has a pin on hood. Tubular front will drop some as well and got some other things in mind.
I look at this way if i could get my old 4,000lb G8 to trap 134+ what could I get this car to trap with the same power as the G8 and even lighter than the C6
I'm going to do as much as i can to get it down a good amount.
Plan is fiberglass front and rear bumpers that will drop 70-80lbs car already has a pin on hood. Tubular front will drop some as well and got some other things in mind.
#38
10 Second Club
Thread Starter
iTrader: (19)
Join Date: Nov 2003
Location: STL
Posts: 3,494
Likes: 0
Received 0 Likes
on
0 Posts
It was starting to get depressing working so much and not touching the car in over a month so i decided to buy the crank and rods finally for the build. Next month I'll get the rest of the goodies to complete the short block at least.