5.3 steering pulley
Thread Starter
TECH Enthusiast
Joined: Sep 2014
Posts: 732
Likes: 1
From: alburnett, iowa
5.3 steering pulley 
I been working on my 76 skylark today. Changed out subframe with the one I done up suspension parts/paint. Went to put steering box in place and I have pulley clearance issue. Anybody know what pulley will work with truck accerories. Pulley I have is 6 3/4 round need to get one 5-6 inches round.
Thread Starter
TECH Enthusiast
Joined: Sep 2014
Posts: 732
Likes: 1
From: alburnett, iowa
Thanks guys I auctually got a different pulley. I used dorman 300-130 I found it had a little better offset than the 300-201. They are made of same material. Im not sure what bracket set up you have. But comparing my original 2006 silverado 5.3 pulley this one looked like closer match. I got it together and got belt to line up staight by putting 2 flat washers between bracket and pump. Had to shorten rear support bracket as well. Put straight edge from crank pulley over steering lines up straight. I now have about 3/4 inch clearance between pulley and steering box.
