72 Comet with a turbo/LS 5.3 in it's future.....
#722
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2014
Posts: 735
Likes: 32
From: Pinellas Park, FL
Thanks.....
Got everything all bolted in, brakes on and bled..... I have 1 little mod to do on the exhaust and I'll get the drive shaft shortened this week, then we should be ready to go again.....
Got everything all bolted in, brakes on and bled..... I have 1 little mod to do on the exhaust and I'll get the drive shaft shortened this week, then we should be ready to go again.....
#724
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2014
Posts: 735
Likes: 32
From: Pinellas Park, FL
The one I set up this weekend was a US Gear, went in first shot no problems at all....
#725
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2014
Posts: 735
Likes: 32
From: Pinellas Park, FL
Finally all back together..... Went through the gear break in cycle, drove it around some Sat and Sun to put it through a couple heat cycles..... Everything seems fine so I reset the cal-tracs and recheck the front end alignment..... I'll probably drive it a some the beginning of the week and get it back out to the track on Wed nite!!!!!
#726
What's up with the Wed night track situation? I'm local and have never been to the track here. I'd be interested in coming by for a bit.
Tipsy
#728
#729
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2014
Posts: 735
Likes: 32
From: Pinellas Park, FL
Got it to the track Wed nite..... She leaft harder then ever right up to 1 sec into the pass when it had a catastrophic planetary failure..... It only had a rebuilt 1.76 planetary set, but I still find it hard to believe it gave up off the footbrake..... It leaft on 3.5lbs and was at 18.6lbs at 4 tenths into the hit, it was going to be a good run.....
Here is the carnage.....
Here is the carnage.....
#731
#736
Thread Starter
TECH Enthusiast
iTrader: (6)
Joined: Aug 2014
Posts: 735
Likes: 32
From: Pinellas Park, FL
Ya play with fast cars and ya get a lot of broken ****..... Just how it goes.....
Got the trans parts this week..... The trans is all back together and ready to go back in tomorrow morning.....
Here's the new FTI 1.80 straight cut planetary set I got for it, and then the trans back together.....