LS3conversion- what front springs to use?
Thread Starter
Registered User
Joined: May 2015
Posts: 3
Likes: 0
LS3conversion- what front springs to use? I am doing and LS3 4L65 conversion on a '67 Lemans convertible. Since the LS3 weighs a lot less than the 326 I need to know what front spring to use on it to get the right height back to what it was. Car does not have AC. Does anyone have an experience with this and can help me? Thank you.
I swapped mine for a set of QA1 adjustable coil overs on the front of my 64 so I could precisely set my ride height. If your on a budget and it's sitting a bit too high I would just cut half a coil off and check the height.
Trending Topics
Thread Starter
Registered User
Joined: May 2015
Posts: 3
Likes: 0
springs I think I can use 6 cylinder springs because the motor weight's seem to be about equal, but there are multiple different springs, which ones would I use? Thanks for the help. This just a daily driver, not trying to make it a race car or raised up too high. Just needs to be as close to stock as it be. Thanks
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
