LY6 (van) pulley options
Thread Starter
On The Tree
Joined: Sep 2010
Posts: 197
Likes: 1
From: Phoenix, AZ
LY6 (van) pulley options Was hoping to find a smaller diameter power steering pulley for my project. It is an LY6 out of a 2009 van.
Can anyone give me some other vehicle models to look at with the same pulley alignment?
I tried one one from another thread on here that claimed to work on an LY6 and it’s 1/2” off. Assume they got their LY6 out of something other than a van.
Thanks!
Can anyone give me some other vehicle models to look at with the same pulley alignment?
I tried one one from another thread on here that claimed to work on an LY6 and it’s 1/2” off. Assume they got their LY6 out of something other than a van.
Thanks!
Thread Starter
On The Tree
Joined: Sep 2010
Posts: 197
Likes: 1
From: Phoenix, AZ
OK, so I was able to use washer on the installation tool to push the Dorman 300-202 pulley on further and it’s going to work, but I need to find a lower head on the pump mounting bolt.
Saw another thread where someon used a button head bolt.
Saw another thread where someon used a button head bolt.
See this page. I used spacers between the pump and bracket and button head bolts. Post 54
https://ls1tech.com/forums/conversio...2-build-3.html
https://ls1tech.com/forums/conversio...2-build-3.html
Thread Starter
On The Tree
Joined: Sep 2010
Posts: 197
Likes: 1
From: Phoenix, AZ
Modified this 2 arm puller to get the pulley back off!
Worked like a charm! (Can’t upload photo from my iPad....sorry). Anyway, it’s a neato puller, wish you could see it......
Now now I can use some spacers and button head bolts. Should be good to go.
Learning the hard way since 1964.
Worked like a charm! (Can’t upload photo from my iPad....sorry). Anyway, it’s a neato puller, wish you could see it......
Now now I can use some spacers and button head bolts. Should be good to go.
Learning the hard way since 1964.
