1989 Z24 with LS power
#5
TECH Resident
Thread Starter
iTrader: (55)
Join Date: Oct 2005
Location: Cleveland, Oh
Posts: 847
Likes: 0
Received 0 Likes
on
0 Posts
Actually I measured a fbody engine bay and this one and both were 30"x30" so I knew it would fit. I do have to cut the fire wall for the trans. I bought a fbody tunnel and am in the process of fitting it to my floor. I will be putting in a cage and running it tight to the pillars so it is hidden also I will be running tubing along pinch welds and making an "X" brace in the center to strengthen it up.
I figure a turbo and a good muffler should make it quite enough to suprise people
I figure a turbo and a good muffler should make it quite enough to suprise people
Trending Topics
#11
On The Tree
iTrader: (10)
Join Date: Jun 2006
Location: Warren,IN
Posts: 100
Likes: 0
Received 0 Likes
on
0 Posts
That cool I allmost did this back in 02 but the cost was so much higher than putting a 3.8SC in. you useing a custom k member? I was going to use a old fox body k member. If i knew someone was going to do this i would of gave you my independent rear end i was going to use out of a corvette but i already sold it makes me wish i did this setup . can't wait to see it finished
#13
TECH Resident
Thread Starter
iTrader: (55)
Join Date: Oct 2005
Location: Cleveland, Oh
Posts: 847
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys! I am using the stock front and modifying it/ restructuring it. I would have loved to have that corvette set up but my limited budget is goin 4-link. I will get a pic of the fbody tunnel as soon as I clean it out from transporting it i put all the parts inside. Unfortunately this freezing weather here is slowing me down.