whats the best intake for a c5 z??
#26
i have been searching on this topic for my 02 Z06. Here is what i have found
vararam = the biggest improvement in the 1/4. The most popular on the vette forums. BUT its fit and finish are not so good. Some have reported problems with water getting up to the filter / some say they have never had a problem though. Good bang for the buck.
honker = the best fit and finish on the market. Makes great power on the dyno. It cost a lot more than the other kits out there by 100 bucks. Some report it sucks in hot air from the rad. at idle/stopped in traffic/stagging lanes/etc. A lot of tuners use them on their turn key cars
I am going with the callaway honker kit. The fit and finish alone is worth the extra money for ME. The kit makes good power also.
vararam = the biggest improvement in the 1/4. The most popular on the vette forums. BUT its fit and finish are not so good. Some have reported problems with water getting up to the filter / some say they have never had a problem though. Good bang for the buck.
honker = the best fit and finish on the market. Makes great power on the dyno. It cost a lot more than the other kits out there by 100 bucks. Some report it sucks in hot air from the rad. at idle/stopped in traffic/stagging lanes/etc. A lot of tuners use them on their turn key cars
I am going with the callaway honker kit. The fit and finish alone is worth the extra money for ME. The kit makes good power also.
#27
My vararam hydro locked my motor in about of foot of standing water in an intersection where the mother side had a sharp dip. $350 for a vararam and $500 for a new LS2 well....... that my deductable and they wont swap in an LS3 if I pay the difference