Randy WS6

iTrader: (69)

I built the engine a few years ago for the street and desided to take it to the track and this is my times, engine specs is in my sig.. And what would a round about 1/4 mile times would this come out to be.

60ft. 1.444
330ft. 4.276
594ft. 6.197
1/8th. 6.625
MPH. 105.15

dlk1950

That's a real nice 1/8...6.625 x 1.57=10.401

ls1freak33

iTrader: (16)

that is a hell of a 60ft man u on all motor?

Randy WS6

iTrader: (69)

Thats on Hoosier D.O.T. DR. 335/35/17's and (nitrous)

ls1freak33

iTrader: (16)

that still a good 60ft have u tried goin on motor seenin wat it does??

zracer323

iTrader: (12)

With that setup I would actually expect a little bit better 60 if your spraying off the line. Either way, nice times!

Randy WS6

iTrader: (69)

Me to, But on foot brake, i can only stall it up to 3100, I have a trans brake but ,it has a delay in it ,so i want to do a little more testing with it before i try it at the track. Ill be going back to the track in two weeks and hope i can use the brake, then i can stall it up to 4800rpm, Then i hope my 60ft will come on down.
I was pulling the front tires a bout two feet and landing hard on the frame, so im going to setup the front shocks to try to stop the lift, but still keep rear traction. And also spinning the tires on the rims , I may haft to screw it.

Randy WS6

iTrader: (69)

My car is not full weight, it has a tubular K-member & tubular front and rear bumper supports , but still has the complete stock interior, power seats and all and AC. and the motor is four years old, a lot of hard steet time on it, need freshing up. What do you think will help me get a better 60ft.with what i have ?

1Bad97WS-6

iTrader: (3)

That car runs good. But I time 1.56 with my 1/8 time and its dead on what I run in the 1/4..

ls1freak33

iTrader: (16)

thats pretty sweet time in the 60' wat stall u running in your tanny i got a friend with a 4k stall cuttin 1.5's and 7.4's all mortor