78novacaine

iTrader: (2)

if you get that thing to hook, you should see some easy low mid 12's like has been said, the mph is definitely there for at least that

candyblueta

iTrader: (16)

heads arent ported but they are built. i weigh around 200lbs. i will see about getting the tune looked at and re-done.

urbanhunter44

iTrader: (1)

on stock heads a shiftpoint of around 61 or so will probably work best, however that cam wants RPM and air, not a good cam for stock heads at all.

If you aren't tuned then the problem is obvious..

chas010

iTrader: (3)

10.5 to 1 compression? was that estimated? for comparisson my cam only (503) 95 a4 z28 runs consistent 12.1s at 111 with a 1.68 60ft.

jakesz28

iTrader: (9)

I'm running the same cam(untouched heads) without all your bolt ons and running 12.5's at 108 on the motor. A lot can be lost on a mailorder tune. On the motor I pull 1.58 60 foot times. When I had my car on the dyno the horspower did not drop until the rev limiter came in at 6500. So I would say my car could go 6600-6800.

candyblueta

iTrader: (16)

so we all vote the tune???