How does this catch can look?
#1
How does this catch can look?
I don't know a lot about this stuff, but its small, "lightweight" , cheap, and recirculating? Anyone see something I don't?
http://www.jegs.com/i/JEGS/555/511000/10002/-1
http://www.jegs.com/i/JEGS/555/511000/10002/-1
#4
On The Tree
iTrader: (9)
Join Date: Nov 2009
Location: White Pigeon
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
I don't know a lot about this stuff, but its small, "lightweight" , cheap, and recirculating? Anyone see something I don't?
http://www.jegs.com/i/JEGS/555/511000/10002/-1
http://www.jegs.com/i/JEGS/555/511000/10002/-1
Trending Topics
#14
so the hose goes from the radiator to the top inlet of the can i guess, but what about the bottom outlet..where does this go?? the stock reservoir only has one inlet !
#16
Race your car!
iTrader: (50)
Hook the line from the radiator to the bottom of the can, that way it will suck the fluid back into the radiator as the coolant cools off, the top of the can, run a hose the length of the car and let it dump behind the rear tires, preferrably in the centerish of the car under the bumper cover, so if you ever do push any coolant during a track pass it will not hit the tires and cause you to lose it on the top end. I have a non-recirculating type I ran for a while, but I used to just run the radiator a touch low so under normal conditions nothing other then a drop or 2 would get into the overflow... and if more then that got there, then that was a way I knew I had a problem (pushing water)
Never did see any amount get into the can, unless I topped the radiator off. As a general rule, I wouldn't do it this way, I'd hook it up so it will recirculate, and just make sure the overflow hose, is routed to a safe location should it ever happen.
Never did see any amount get into the can, unless I topped the radiator off. As a general rule, I wouldn't do it this way, I'd hook it up so it will recirculate, and just make sure the overflow hose, is routed to a safe location should it ever happen.
#20
Teching In
iTrader: (3)
Join Date: Nov 2007
Location: IL
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
I hated filling mine through the 3/8 hole on the top,also It's a pain to see how much you have got in there so I drilled and taped the two fittings it came with with a 1/8 npt tap and ran two hose barbs and a clear line from the top to bottom so now it has a sight glass.