Those of you with an Accufab 4-barrell TB
09-18-2010, 07:54 PM
#22
TECH Enthusiast
Thread Starter
iTrader: (31)
Join Date: Jan 2002
Location: Waxahachie, Texas
Posts: 557
Likes: 0
Received 0 Likes
on
0 Posts
It looks the same as the pics in the original post except the TB is turned around 180 degrees. Now i Just need to mount my WOT switch and K&N is assisting in building a one off filter for my needs
Looks like your hood wont close over yours with both plates on that super vic?
I will get a few new pics up in a bit. Car runs much stronger after removing the low profile elbow and FAST 92 tb
Looks like your hood wont close over yours with both plates on that super vic?
I will get a few new pics up in a bit. Car runs much stronger after removing the low profile elbow and FAST 92 tb
09-18-2010, 09:32 PM
#23
TECH Enthusiast
Thread Starter
iTrader: (31)
Join Date: Jan 2002
Location: Waxahachie, Texas
Posts: 557
Likes: 0
Received 0 Likes
on
0 Posts
Here are some pics from tonight after a cruise.... I still need to put the cowl cover back on but I cracked the windshield pulling the passenger wiper off and need to replace it first. The last pic is with the stock WS6 hood fully closed, there is almost an inch and a half clearance.
Oh, the screw on plastic cover is homemade and seals tight enough to keep water out.
Hood fully closed, 3/4 of the throttlebody is behind the hood
Oh, the screw on plastic cover is homemade and seals tight enough to keep water out.
Hood fully closed, 3/4 of the throttlebody is behind the hood
