do relocation brackets really help your 60'
Thread Starter
TECH Senior Member
iTrader: (48)
Joined: Jan 2002
Posts: 7,354
Likes: 1
From: Columbus, ohio
do relocation brackets really help your 60' if you have a stock height car, will the relocation brackets still help out any
a little, lot or none?
i havent seen tomay peolpe get them and i thought they helped out a lot.
are they worth it.
a little, lot or none?
i havent seen tomay peolpe get them and i thought they helped out a lot.
are they worth it.
TECH Fanatic
iTrader: (1)
Joined: May 2002
Posts: 1,396
Likes: 1
From: Hot Rainy Humid +2000 DA South Florida
They helped my car out quite a bit. I was cutting 1.46-1.48 60's on average before I added then. Never had a problem hooking but I added them for the hell of it. I keep them set at the lowest/steepest angle and have been cutting 1.40-1.42 60's average now.
I would recommend them, easy mod to do and after install you have 3 different LCA angles to play with.
Lee
I would recommend them, easy mod to do and after install you have 3 different LCA angles to play with.
Lee
"All Motor 9 Second club member"
iTrader: (60)
Joined: Nov 2001
Posts: 3,235
Likes: 2
From: On the Bumper!
Well worth it no doubt. It also helps to eliminate wheel hop which can destroy a rearend in the blink of an eye. It's an easy and effective mod that I think is under rated.
Good luck to you!
James
Good luck to you!
James
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo "All Motor 9 Second club member"
iTrader: (60)
Joined: Nov 2001
Posts: 3,235
Likes: 2
From: On the Bumper!
Actually I do run them on my car. I just recently installed them though. I run the BMR bolt-in brackets and I tacked them in once I had them loaded and locked in. I set them at the lowest (most angle) setting. I wanted the most traction possible and they definitely provide that. It was very noticable. The first time out the wife pulled a 1.47 in full street trim on ET streets when traction on those would have been questionable. You just can't win a race if you are spinning.
I hope this helps. Good luck!
I hope this helps. Good luck!
i strongly recomend gettign weld ins. it is a bit mroe work than the bolt ins, but the brackets are basically holding over 1000lbs of force each in a modded car that hooks good(figure a 60ft in the 1.6's)
later
tim
later
tim
