93LS1RX7

iTrader: (8)

It would be an interesting heads up with you and me. Your 10.6 to my 10.7!!

Can I get .1 on you at the tree??

Fireball

iTrader: (21)

that 10.6 isn't gonna last long...car is gonna be 100+ lbs lighter and have more tire to stick

93LS1RX7

iTrader: (8)

Good lord willin a 408 stroker will be in between my frame rails before July so lets giddy up.

JS

iTrader: (4)

Last time I checked a light car with a 408 WASNT a 3400lbs H/C TA
Apples to apples I think Brians got a good shot at the 10.37 H/C (hyd) Record in his car...

93LS1RX7

iTrader: (8)

Oh he has a fast car and I am sure he will set the record, I was just giving him a hard time.

JS

iTrader: (4)

Fair enough

Fireball

iTrader: (21)

getting all that to stick to the track will be a different story

93LS1RX7

iTrader: (8)

No doubt. Right now it isnt a problem but that is a lot more torque.

ricethis98

what size belt do u need if getting rid of the PS pulley????

Camaro_Zach

iTrader: (19)

if you have no power steering...then if a hose clamp comes off...you stand the risk of having *gasp*! no power steering....sounds risky to me!

ricethis98

what size belt do u need if getting rid of the PS pulley????

Jake the SSnake

iTrader: (11)

I ordered all the parts listed from summit and should have them by the end of the week.I read on here somewhere that you need a 52 inch belt so thats what im going to try.It also depends on whether you have a u/d pulley which i do.

ricethis98

i dont have an underdrive pulley, will 52 inch belt work for me?

Jake the SSnake

iTrader: (11)

I think you need a slightly longer one not sure how much? Im sure if you search you will find it.

oOoLy

I need to Delete the PS, I want to know what I need of parts to order it from summit, if you have the part numbers also and any pics plz ?

Jake the SSnake

iTrader: (11)

All of the part #s are at the beginning of this thread I just installed mine tonight I only used about 18 inches of hose.Everything together,hose and fittings cost about 80$ through summit

oOoLy

Any pics plz ??

Jake the SSnake

iTrader: (11)

I had to remove the bottom alt bolt but it seems to be sturdy enough w/out it.I used a gates belt K060512 and could have gone a little bit longer.This is with an asp u/d pulley.

Steve Burger

iTrader: (33)

How do you route the belt?

valetudo

I have an RX-7 with manual rack and LS1 and I want to delete power steering. What size belt do I need since I don't have an underdrive pulley so 52 inch won't work. Also.. I don't see how the belt should be routed, it seems like it will allow less belt contact with the water pump no matter what I do...

~Bob