Soul TKR

iTrader: (4)

has to be one of the nicest cars on tech...

BADSZ28

iTrader: (39)

I just pulled mine to see what it was like. It can't weigh more than 10lbs. Not worth it IMO. But it does open up the front end for more air. So I am debating making a ram air set-up from the nose or putting it back together.

dmart

iTrader: (3)

Just did mine and it felt a lot heavier than that, maybe I'm just a weakling.

CamaroRacing12

iTrader: (5)

yea i just did mine also... (LT1) and felt at least 20lbs 20lbs right off the nose sounds damn worth it to me

3rdgen92maro

iTrader: (20)

just did mine last week. both front and rear. couldnt be happier

REDGAR

As old as this thread is I am surprised has not been asked or I am really out of the know.

Where are the air bag sensors?

Sideways240sx

iTrader: (22)

My bumper support is out on a 98 ta. No sag.

Good point on the air bag sensors, i have yet to see them.

Chris

STANG KILLA SS 2

iTrader: (6)

mine is under the console/parking brake area inside the car.

Driftunit

iTrader: (5)

^ i dont think thats the sensor. if im not mistaken i think the sensors are up front somewhere and they connect into the thing in the parking brake area then go to the actual airbags

nemss1

as far as i have heard, that module is an intertia swith which also controls the deployment of the airbags in a crash

dreamls1

iTrader: (25)

I did it too, to problems. That thing was heavy too

Driftunit

iTrader: (5)

do you have to remove the tail panel to take out the rear bumper support?

Z-RATED94

iTrader: (6)

I don't believe so.

Steve Burger

iTrader: (33)

If the cover needs to come off then yes. Some times you can get lucky and slip the suppot past the cover.

JUICED96Z

iTrader: (2)

I thought about doing it but in a street car I realized its not worth the cost and possible leagal issues if someone hit me or I hit someone.....


I can see it now, I hit someone or someone hit me and they get hurt because there was no crash bumper then they notice its a built car and don't say much... then see that the crash protection stuff has been removed..............

tomz28

iTrader: (20)

im going to try this

Deerhunter-Z28

Took both of them out, a good 40+ pounds off the car.

BADD SS

iTrader: (4)

Well, I weighed my front @ 18.5 lbs, and rear @ 21.5 lbs... Both now are supported by 1.75" .125 wall aluminum tube,, and 3/16" plate which weigh 5 lbs front, and 4 lbs rear. Better then nothing.... and 31 lbs lighter then stock..

tomz28

iTrader: (20)

how about some pics?????

BADD SS

iTrader: (4)

Not my nicest welds but it was a quickie, have no pics of the rear...