OutlawZ

iTrader: (4)

absolutely beautiful.... great job....

Beaflag VonRathburg

iTrader: (176)

Your rear metal work is very nice. Did you make the new trans tunnel or buy that some where? I want to do that to my 93 so I can really slam it.

98 Silver Bullet

iTrader: (28)

I made it. I just bought a 4 x 8 sheet of .045" aluminum. I made patterns out of poster board and used them for the carpet as well.

sr71bbjr

iTrader: (52)

looks great man..Nice to see the trans cooler in the rear...You going to run a parachute mount off that cross bar in the trunk area?

87Lt1Monte

iTrader: (1)

Im going to be doing a bbc in a 98 firebird What kind of header are you using?

Anti-Vnm

iTrader: (14)

Very nice work. Look good!

Beaflag VonRathburg

iTrader: (176)

Then from the looks of it you just used rivets and silicon sealant? Thanks for the information.

EDIT: I'm going to be mocking this up tomorrow. How far from the top of the hump did you start cutting?

98 Silver Bullet

iTrader: (28)

If you are referring to piece of tubing the fuel pump is mounted to, that is only ¾” chromoly tubing. If I get to the point where I need one, and I hope I do, I will just get one from a sponsor that attaches to the rear bumper mounts.

As far as the fabricated hump, I just started cutting, working around the seam that is about halfway up that back wall.

JUICED96Z

iTrader: (2)

Looks nice man.


I also have a weird looking thing that WAS on top of my BBC.



I call it my sleeper carb...... looks are VERY deceiving........

Nice motor also man.