brandonppr

iTrader: (9)

I bought a Flaming River Pinto rack from someone parting out a 2000 Camaro that they were building as a race car on Ebay.

I got the rack today.
I am going to buy a PA Kmember with pinto mounts, what about the steering shaft? How will it connect? Flaming river told me the one I have is 9/16 26 spline. Do I have to have a different shaft or will the stock shaft work?

CanuckSS

iTrader: (13)

You will need a new u joint to fit on the rack. They are kind of pricey, I bought mine at the lsx shootout last year from Chris Alston. I then bought a piece of tubing that would fit into it and then cut the bottom part off of the factory shaft and welded the new tube to the factory shaft. I hope this isn't too confusing.

I guess an alternative would be to buy one from Madman or from BMR.
Good Luck.

brandonppr

iTrader: (9)

I talked to PA today and they told me that had a shaft that would work. Thanks.

MADMAN

iTrader: (4)

The stock steering shaft will not work on the manual rack. I have a kit I can send you that will make it work.