347 & d1sc @11 psi
Thread Starter
On The Tree
Joined: Nov 2008
Posts: 185
Likes: 0
From: Kuwait
Very nice! Which size pullies are you running? What is your total timing? (with and without meth if you change it)
My '02 Z28 with a bone stock motor and a D1SC with 8# pullies put down 479. Since then I have upgraded to larger (4.5") intercoolers and big *** cone air filter (FWIW) but have not been back on the dyno.
Wish I had a forged motor so I could up the boost.
My '02 Z28 with a bone stock motor and a D1SC with 8# pullies put down 479. Since then I have upgraded to larger (4.5") intercoolers and big *** cone air filter (FWIW) but have not been back on the dyno.
Wish I had a forged motor so I could up the boost.
also the gas we use here has a bit higher octane which is about 95
Thread Starter
On The Tree
Joined: Nov 2008
Posts: 185
Likes: 0
From: Kuwait
here is a vid of the car on the dyno
http://www.youtube.com/watch?v=0fYQ8z63_RQ
i will post up the idle vid later on today
http://www.youtube.com/watch?v=0fYQ8z63_RQ
i will post up the idle vid later on today
i have almost the same setup, except 6.0 and cnc'ed lq9 heads-not sure why were almost 150 hp apart-i have 488 rwhp, ran 10.68 @ 126 mph
i need to use a dyno with a softer load i guess, lol
i need to use a dyno with a softer load i guess, lol
