So close to 700 rwhp

Reply Subscribe

Thread Tools

Search this Thread

Oct 5, 2010 | 08:41 PM

#41

jjcamaro02

Thread Starter

9 Second Club

iTrader: (34)

Joined: Jul 2008

Posts: 342

Likes: 3

From: buffalo,NY

Quote:

Originally Posted by fastlt1

Did you order your trans with 300M Billet 2wd output shaft?

No stock shafts, should have upgraded but no problems yet.

Quote:

Originally Posted by gruntwork

Awesome numbers and track run! This is the direction I plan on going with my car.

Did you get your compression that low with only the 317's or with the shortblock, or both?

What tires (type and size) are you running on the vid run?

Thanks it has been a lot of money and hard work.
The compression was lowered for the heads and pistons. It is less than 9.5 compression.
The tire size is 325-50-15 MT drag radails

Quote:

Originally Posted by blue00ZZleeper

Cutouts pick up A LOT of power on procharged cars...its proven lol...also add meth and bump up the timing a little bit. Are you getting any belt slip? That a awesome setup...I'm in the middle of a 370ci with the blower maxed on rpm with methanol...I hope to break 730+ but I'm also 6spd...which means no awesome times like your car lol

yes at the track I run single 3 inch with no muffler. I plan on building a single 4 inch system over winter. Meth is also next inline i am running 18 degrees of timing so there is more power to be made.
I am getting belt slippage, SDCE may also be in the future.
Good luck on your build.

Reply Subscribe