Finally put her on the rollers today. It was impressive and scary all at the same time.
I was very happy.

https://www.youtube.com/watch?v=eLz6...ature=youtu.be

Put down 738 RWHP & 700Torque

 

 

As mentioned on the other board.. Impressive with a lot more et in it..

 

Looks and sounds great!

 

Thanks man. Is your rig boosted yet ?

 

Awesome. I'm doing a 70 Stepside turbo build this winter. This pumps me up!

Also...sorry but the music makes the video tough to watch. I can't hear that sweet turbo action nearly as well!

 

Benlugchev - Couldn't watch the video at work. Noticed you're running a Muncie 4-speed...impressive to say the least. Is it a M20, M21, or the famed M22 rockcrusher? How is it holding up to all that power? Congrats!

 

I had an auto gear M22 in it for year or so. Held up fine with this power. I just swapped over to an 80e for ease of driving.

 

after some more fine tuning and addition of the 3rd gear 80e mod. my rig went 10.1@133mph. 60'@1.54. Launching on the foot brake @10#, then full boost 17#

Ran 3 solid 1/8 mile passes all at 6.6 or 6.7 @107..then slamming the brakes
Only got to run this 1 10.1 pass out the back door this time before getting my wrist band cut...again

new video coming.
here is the slip#695

 

Very nice!!

 

 

Very beautiful truck im doing a 70 long bed like this twin turbo next year do you think a 3 in down pipe would clear the heater box?

 

I gutted my heater box and installed aftermarket heater under the passenger side dash. If you mout your turb way upfront like I did the you could prob squeeze 3" down that side staying on the outside of the frame rail. I would think the driver side would be more challenging. Good luck