Car has Blackwing intake/ported stock TB/Kooks longtubes and x-pipe/Corsa axleback. Ed Curtis custom grind variant of the streetsweeper HT/ATI 10% UD

Had it installed and tuned @ New Era Performance.

Car put down 407/381.

I must say I'm very happy with the results.

Dyno graph attached

 

Very nice!

 

Care to share the specs? Numbers look good

 

Specs are 227/231 .618/.607 111 lsa I believe.

 

Nice numbers!!

3 threads on the same subject...you must be stoked!

 

Haha I wasn't sure what section to post it in!

And yes just a little. A lot of time and reading went into my selections. Happy it's done and worked well. Time to start reading about heads

 

Nice specs

How's it drive bud?

 

Great numbers, Thorny! Gotta love that broad torque curve...bet she pulls hard.

 

Great numbers!! That's a great gain for the mods!!

 

Thanks guys. Car drives great. I'm happy with the outcome and with Ed Curtis's custom grind and Mike @ new era's tune I couldnt be happier. Those guys know what their doing. Car is honestly scary for only 407/381. I wont lie it is all over the place when i floor it in first at 2500k (in gear not dropping clutch at 2500k)... i havent even shifted it to 5500k into second yet. I have the stock tires on the rear only 275 and the compound sucks. still waiting on the nitto nto5r radials i ordered back in march..

 

Very nice numbers OP. Hard to beat an Ed Curtis cam. That little old Streetsweeper HT cam has always laid down impressive numbers for the size. Glad you're so happy with it OP. A whole other animal I'm sure.

 

congrats! This is my next cam... is this through an m6?

 

[QUOTE=airforcemanss;18806150]congrats! This is my next cam...

 

good results.i like my Ed Curtis cam as well

 

Ok let's hear it!

 

Nice numbers, I love that cam, drives great in the mid range in my car.