Procharged D1X 8lbs of boost
#1
10 Second Club
Thread Starter
Procharged D1X 8lbs of boost
Finally got my WS6 #3392 on the dyno today. Below is the list of power mods rest of mods in sig. Before the D1X it put down 440hp, 399tq, after 625hp, 499tq. That is a gain of 185hp and 100tq with 8 to 9 pounds of boost. I am running Snow performance stage 2 Water/Methanol Kit. Also is has a very safe tune on it.
BTR LS3 Centrifugal Supercharged Camshaft,
Trick Flow As Cast 220 heads
Fast LSXR 102, NW 102 TB,
Procharger D1X,
Kooks LT's/True Duals
The following 2 users liked this post by WS6 #3392:
capelajc (08-13-2022), Snake_Skinner (08-14-2022)
#4
Super Hulk Smash
iTrader: (7)
What fuel system are you running? Lonnies dual pump and stock lines? What injectors?
That cam works very well with the D1X... nice tabletop flat torque curve with the centri-blower.
If you don't have upgraded lines and you do those, you can def push to 14-16 psi... stock block might take that for a while and get close to the 800s. Looks like you're making about 20hp per PSI... so you should be able to extend that out to 14... so another 100 to 16... another 140whp. I don't know what the blower speed looks like... but you might even be able to get to 18-19 psi. Which would add about 200whp over where you are if you wanted to push it with a forged block down the line.
That cam works very well with the D1X... nice tabletop flat torque curve with the centri-blower.
If you don't have upgraded lines and you do those, you can def push to 14-16 psi... stock block might take that for a while and get close to the 800s. Looks like you're making about 20hp per PSI... so you should be able to extend that out to 14... so another 100 to 16... another 140whp. I don't know what the blower speed looks like... but you might even be able to get to 18-19 psi. Which would add about 200whp over where you are if you wanted to push it with a forged block down the line.
The following users liked this post:
Snake_Skinner (08-14-2022)
#5
10 Second Club
Thread Starter
I am running Lonnies twin high output fuel pump kit with Hobbs switch, with stock lines and ID1050 injectors. Everything has worked together better than I thought. Below is the last dyno chart running the M1 methanol, and no other changes.
#6
11 Second Club
iTrader: (1)
Join Date: Mar 2006
Location: Simpsonville, SC
Posts: 349
Likes: 0
Received 0 Likes
on
0 Posts
I like the build!! Great numbers! I have a F1A I am installing soon hoping i can turn it down enough to make the power you are making and later do a forged short block and turn it up.
Last edited by 99T/AMAN; 03-03-2019 at 08:34 PM.
#7
10 Second Club
Thread Starter
Thank you! I planned this build out better than the first one I did. Making same power but with 6 lbs of boost less.
Trending Topics
#9
10 Second Club
That thing has got to be just a blast to drive! That torque pulling you all the way to a shift point will flat hold you in the seat.