Finally got my Z tuned, happy w/ results...
06-07-2006, 08:20 PM
#1
12 Second Club
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: Ohio
Posts: 836
Likes: 0
Received 0 Likes
on
0 Posts
Finally got my Z tuned, happy w/ results... Well, I decided to go ahead and get my car dyno tuned by Jeff Creech @ CAM in Durham, NC and well, I started the day with a baseline 300HP/313TQ at the rear wheels. A little off from when I got it dyno'd in April(was cooler then). After getting my A/F ratio down in the 13's& 14's he then gave it some tuning. Well, needless to say my end result was 320HP/330TQ at the wheels. I dont think that is too bad for the bolt ons that I have and a mid 80 degree day. What do you all think?
06-07-2006, 09:04 PM
#2
TECH Fanatic
iTrader: (3)
Join Date: Jun 2004
Location: Dayton, OH
Posts: 1,844
Likes: 0
Received 0 Likes
on
0 Posts
Considering your mods and that it is an A4, lookin' good. 
EDIT: I just noticed that you are from Dayton. Are you on www.dayton-fbody.com ???
EDIT: I just noticed that you are from Dayton. Are you on www.dayton-fbody.com ???
06-07-2006, 10:03 PM
#4
12 Second Club
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: Ohio
Posts: 836
Likes: 0
Received 0 Likes
on
0 Posts
I am on Dayton Fbody.com under the same screen name. I am in NC though with the Marines. I aint dissapointed with the numbers at all. Just gonna wait a few more miles and save some money and do the Head/Cam swap. Maybe around 80,000 miles. I dont know
06-07-2006, 10:05 PM
#6
12 Second Club
Thread Starter
iTrader: (11)
Join Date: Aug 2005
Location: Ohio
Posts: 836
Likes: 0
Received 0 Likes
on
0 Posts
Oh yeah, I got the dyno sheet but my scanner/printer just died recently. I need to try to get them electronically. I just hope the A/F ratio stays in the range it is in now. From April till today it stayed in the same range so it will probably have no problem.
