svodave

Car is a 2000 Z28 6 speed, stock rear 3.42.......

Made 405 HP/370 TQ

AFR was in the high 10s to low 12s so it could stand to be leaned out a bit.

Mods are.........

SLP lid
ported TB
LS6 intake
Ebay headers and O/R Y
Magnaflow CB
Vindicator cam pkg

This was done using a mail order tune. I figure getting an underdrive pulley and a tune on the dyno could pick me up another 20 HP at least. I'm glad it broke the 400 RWHP mark though! Will post graph ASAP.

XS HP

Not too shabby. I'm sure with a better A/F you could pick up some good power.

blu byu EH

iTrader: (25)

damn put a 100 shot of spray and she will be bitch

LT194CamaroZ

iTrader: (15)

is this on a 112 or 113 LSA, hows it drive?

'Trust'

iTrader: (24)

High 10's to low 12's? Thats fat, lean that out and get some more power! Great numbers for the A/F

ND4SPD _SS

iTrader: (52)

good numbers. sounds like they'll just get better too. I bet it sounds awesome too.post up a sound clip if you can.

raptorws6

iTrader: (1)

Nice #'s.

MikeG

iTrader: (33)

Solid numbers with a bunch more on the table for sure. Congrats.

180ls1

iTrader: (4)

nice but get a real tune with that agressive of a cam you are asking for trouble. But i would bet you could easily pull out another 15 with a good tune.

bad95killer

I agree

peace

neeshSS

Nice! a lot like my car..i made 406/383.

BayAreaSS

iTrader: (10)

Good results but you'll be smiling even more when you get a tune and a ud pulley

2FNQUIK

iTrader: (17)

how is the vindicator on the low end...i know it pulls mid to top but how rough is it for a dd setup

svodave

A 112 LSA. I use it as my daily driver and it works great. It'll surge or buck very mildly on the freeway if I get under 1,400 RPMs or so. I figure some 4.11's in the back will make it just about perfect. Compared to stock it pulls more on the low end - even harder in the midrange -flat out screams up top! I love it! Great cam!

svodave

Thanks, I'd do a sound clip but I think you'd get bored. The Magnaflow CB is very quiet. The guys at the dyno all agreed it's the quietest car they've ever tested!

Thanks everybody for your opinions. I can't wait to get the UD pulley/Tune.

98blueSScamaro

iTrader: (14)

Read my sig on my setup. I am looking to go back to the dyno with my new zo6 m.a.f kooks 1and7/8' with 4inch mufflex 42 injectors and i good tune. love this cam but you really should get a tune cuz if you do i see your car making more then 410 +

98blueSScamaro

iTrader: (14)

www.fquick.com/Robeertoe

there is a short sound clip on my fquick home page

BlkBird2000

iTrader: (10)

Sounds like a good cam package you got. How much did that run you? Nice numbers too!

PewterScreaminMach

iTrader: (7)

Very nice numbers with the generic tune. You'll definitely pick some more up.

svodave

It was roughly-

$1,400 for the cam/springs/push rods/LS2 chain/oil pump etc..
$900 for all the exhaust.

.....probably another $100 in misc stuff. (oil, plugs, gaskets,etc.)