Low #'s PRC 5.3 2.5,ms3, help?
#21
10 Second Club
iTrader: (2)
Ya,i missed that 90/90.You are definetly down on power somewhere,should be at least 440 with a m6.is the shortblock new,maybe the rings did not seat.You should have a leakdown test done,and a compression test, before writnig off that cam and head combo.I put down 433 on a mustang dyno though a a4,would be somewhere in the 450 range on a dynojet.Did you dyno through the muffler? That will kill 20 hp,from an open cutout.
#22
On The Tree
Thread Starter
iTrader: (3)
Join Date: Dec 2007
Location: Bay Area, Cali
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Ya I dynoed it through a muffler, and the block is new it had 1000 miles on it when i dynoed it. Now there are about 3-4kmiles on it, but what would be a sign of my rings not being seated? Thanks
#23
11 Second Club
iTrader: (2)
Join Date: Jul 2006
Location: Clifton NJ
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Were your numbers with a dynojet or mustang dyno? If you have 3-4k miles on it now, the rings should be seated already. 1k miles is a little low to be dynoing it in my opinion. Don't blame the cam and heads just yet as alot of times you need to tweek things here and there to get the combo to work right. With a little patience and a methodical approach, I'm sure you'll figure out what's wrong.