How much power can i make... !?!?
02-23-2009, 01:47 PM
#1
On The Tree
Thread Starter
Join Date: Sep 2008
Location: WHERE UNCLE SAM SAYS
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
How much power can i make... !?!? Performance:Garrett TwinTUrbo .57mil/TwinTial WG's&BOV's/72lb'ers/Walbro 255/HpTUners/2bar/mAf deLete spEEd DenSity/AEM Meth kit/AEM WIde Band/AEM BoOst/KOoks CaTs/SPinTeCh cAtbaCK...365c.i. forged block, shaved heads(.14), cometic gaskets(.40), steel top rings, aRp head/main studs, Eagle Rods, Diamond-13.7 dished pistons, klevits bearings, IN-motion double row timing chain, Pac valve springs, Performace grind stock crank
drag bags, harrop diff cover, Billet STS,BMR stubs, Gforce CV hAlf shafts, Hendrix 2 piece drive shaft, Hendrix clutch
most recent purchase was new slave, surgetank, bosh inline, fpr, full return fuel setup.
HOw much can i make with the above, and what are my areas the require upgrading to achieve my full potential of this setup? Keep in mind this is a daily driver. If i can make 1000hp id be more than happy to say the least !
drag bags, harrop diff cover, Billet STS,BMR stubs, Gforce CV hAlf shafts, Hendrix 2 piece drive shaft, Hendrix clutch
most recent purchase was new slave, surgetank, bosh inline, fpr, full return fuel setup.
HOw much can i make with the above, and what are my areas the require upgrading to achieve my full potential of this setup? Keep in mind this is a daily driver. If i can make 1000hp id be more than happy to say the least !
02-23-2009, 03:41 PM
#3
On The Tree
Thread Starter
Join Date: Sep 2008
Location: WHERE UNCLE SAM SAYS
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts