just order one........ 
from qa1,player,,,
click on pic 
QA1 Spanner Wrench
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
I had one once, not sure if I still do, but I remember it being pretty cheap. Cheap as in didn't work very well.
Also from memory, while you might be able to lower it with the rings, forget about raising it back up without a spring compressor.
Also from memory, while you might be able to lower it with the rings, forget about raising it back up without a spring compressor.
Staging Lane
Joined: Jul 2013
Posts: 63
Likes: 0
From: NewHampshire
I have QA1 front set up. I am running a lq9 408 PM with your number and ill send you a pic of my car. And a pic of the strut. And the thread count you can try it, and fine tune it for your set up. It seems to leave good. And I like to let em hang off the line at the strip. Because the tuners can't lol. And as far as the wrench goes. Chanel locks work. But I made a better one. I used the stock one for something else.
Last edited by 408-99-f; Sep 5, 2013 at 10:58 PM.