860 Performance

iTrader: (1)

Sorry, no gay ****, just this.

Mike@HSW

iTrader: (6)

Isn't that one of those Jack Lelane Juicers??? j/k

Nautilus

iTrader: (15)

I think now Noyzee owes Vinny the knee pads...

slayer_taunu

iTrader: (3)

LMFAO


so that will go in the factory fill location?

JL ws-6

iTrader: (50)

That's an oddly shaped fuel cell, where is it going?

860 Performance

iTrader: (1)

Its not a fuel cell, its a KY dispenser for Brads center console of his truck. (won't run out at truck stops anymore)

NOZR1

iTrader: (5)

:

Mr. B

iTrader: (1)

ATVracr

iTrader: (5)

Looks like it will go where the factory coolant overflow goes.

Noyzee

iTrader: (37)

looks good vin, i will never run out!!
did you figure on how many gallons?

see you tommorow night to drop off the metal. cant wait to get this all done

Noyzee

iTrader: (37)

correct

JL ws-6

iTrader: (50)

You'll have to build a frame around that though out of tubing because it's outside the frame rails, other then that it looks good.

Noyzee

iTrader: (37)

never heard of that? never had an issue with mine or tim's either, both are outside the rails? is that nhra or ihra or both?

JL ws-6

iTrader: (50)

Definately NHRA, I think it's ihra too. If the fuel cell is in the bumper it has to have a bar around it to be legal, technicnally. IF they look at it. PM steve burger on here and ask him, they just made a bumper support for transam's and are working on a camaro one so a fuel cell can be mounted in the nose, and still be nhra legal, and hold the nose up so it won't sag. Nice piece, I should have the transam one in a couple weeks.

Noyzee

iTrader: (37)

hmm, i will have to look into that.

JL ws-6

iTrader: (50)

Definately, I think it has to be a 1 1/4 inch CM .083 wall tube around the cell if I remember right. Better to find out now then have the cell made and fine out later. It's doable, you can have one fabbed aorund it, but you'll have to pull the nose and fender off most likly to have it done, a fair amount of work unfortunately.

CamaroRacing12

iTrader: (5)

that looks like it will work perfectly... sweet custom fuel cell

ATVracr

iTrader: (5)

By in the bumper I think they mean in front of where ever your frame rails end.

I think you'll be OK as long as you havent cut the frame rails back to far.

Thats some good anti wheelie weight.

Noyzee

iTrader: (37)

yea, i had my 1 gall stand alone in the same spot and never had an issue.
yea, i removed about 100 pounds with y rear 10 gallon fuel cell, and all the lines ect, and moved the pump and filter to the front, and adding about 2 gall to the front cell. plus wheelie bars. im hoping i can keep the car in the 1.2x 60's with the new set up. we'll see

860 Performance

iTrader: (1)

Its 4 gallons.