ebay kit
Thread Starter
Joined: Oct 2007
Posts: 604
Likes: 1
From: Gainesville FL
ebay kit Just want to know how much power can u ready be had with the shitty ebay kit if u would hack the t4 flange and weld on a t6 gt 88 and add a 4 inch down pipe
your going to either have to modify the pipe alot or notch the frame to make a large turbo and 4" dp fit, because the pipes currently put the turbo way to close to the drivers side frame rail to make anything bigger then a 76 and a 3in dp fit
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
I had a pt88 in there but spool time is affected due to the DP restriction. Mine was a PTK not ebay so quality is better. Flip the turbo so the inlet is on the frame side and send the exhaust outside of the passenger side like a manifold kit and youll be good. Good luck with it.
I ran the ebay kit. For the money it is hard to beat. The piping was good quality and the welding was pretty nice also. I had issues with the downpipe but I was pretty happy with it. I did 500whp with an MPT70 @ 8psi, it might have been higher but my clutch started slipping.