I've posted on others threads so thought I would just start my own.

408 iron block LME stroker
Callies crank
Callies rods
Wiesco pistons
Arp fasteners
TEA stage 4 ls cylinder heads
Ls series water pump
Ported ls7 oil pump
Dual timing chain
Mls multi layer steel head gaskets(7 layer)
ls f body pan
Ls1 intake with elbow,fuel rails,throttle body,96lb injectors
Custom engine harness with ecm tuned for set up with ALL sensors
Custom twin turbo it
2-62mm precision turbos
waste gates
custom turbo headers
custom inter-cooler

 

Almost done with car, painter needs to paint the front clip still

 

hoping the rear sits lower after complete

 

Any goals...powerwise?

 

The motor was in another nova and On the chassis dyno, it made 1,088 RWHP at 20 psi of boost on race gas. On the more conservative pump gas tune and 12 psi, the numbers are 786 RWHP

 

wow that is one bad *** nova! Good work!

 

Wow that's a nice build, can you give more spec's on the motor? 4 bolt or 6 bolt heads, what model Callies crank and rods?

What a cool build.

 

Holy Shmoly, THAT looks amazing.

 

killer looking Nova! Those rear tires don't stand a chance

 

What front end is that? Was it made or can you buy it?

 

It is a TCI pro touring front end and 4 link

Thanks for all the comments.

 

Any other info on the headers? Looks badass. Im doing a simular setup on my 69 Camaro Prostreet but am still deciding what to use manifolds wise

 

All hot and cold turbo pipes were made by 417 motorsports. Great work!!

 

Awesome build, very nice!

 

That will be one nice looking car... keep up the great work...

 

Holy **** this is a killer build!! I love the front clip.

 

That entire engine combo come out of Chad's black car? are you in Springfield?

 

Yep, that's who I bought it from and then LME freshend it up and 417 ploshied eveything. Not sure what Chad is replacing it with but have to assume something special

 

LME 427 w/Mast black label heads, twin 76mm precisions backed by a Rossler 4L80. I'm building a 25.3 street 62 hardtop w/AJE strut clip, 6.0 LS9 heads, twin 6262 precisions 4L80. Blake is helping me at my shop with the project.

 

Sounds badass. I super happy I found Chad and got this motor. I got the ECM and tune as well so drop in and go.