WS6 S475 official build thread.......
#681
TECH Fanatic
Thread Starter
While all the stuff was out of the way and the car was up in the air I decided to go ahead and put my cross member in for the torque arm. A comparison picture below shows the Spohn Pro Series beside the stock torque arm. Also the guy came and put deposit on my manual trans stuff so I took it all out.
#682
TECH Fanatic
Thread Starter
Went and dropped money off with my rear end builder. This is the setup.
-Nodular Iron Case
-Full Spool
-Chromoly Bearing Caps with the Big Bearings
-3:18 Gears
-Daytona Pinion Support
-1350 Billet Steel Yoke
Now to order my adjustable LCA's and in a few weeks I can install my entire rear setup.
-Nodular Iron Case
-Full Spool
-Chromoly Bearing Caps with the Big Bearings
-3:18 Gears
-Daytona Pinion Support
-1350 Billet Steel Yoke
Now to order my adjustable LCA's and in a few weeks I can install my entire rear setup.
#684
TECH Fanatic
Thread Starter
Get your wife to video lol. Week after Easter should have center section back. Guy has 7 ahead of me to build and I told him I wasn't in a hurry. But thats the time frame he gave me.
#687
TECH Fanatic
Thread Starter
Took injectors out yesterday. Guy said he's coming to get them today. Also took the turbo kit off. This kit is for sale with all that is pictured in the disassembled picture. Like ive said before im gonna redesign a new kit for a new look.
ON THE CAR...
OFF THE CAR....
All that's left in the car is the engine.
ON THE CAR...
OFF THE CAR....
All that's left in the car is the engine.
#689
TECH Fanatic
Thread Starter
Got the car in the shop yesterday. Methanol kit removed and for sale. Basically a shell now. About to order my 10pt cage just as soon as I decide which one im going with.
#691
TECH Fanatic
Thread Starter
Thanks. It was good on the street. Sucked on the track. There are a few videos on this thread of some street pulls. You can see boost gauge, rpm, speedometer. Just watch lol.
#693
TECH Fanatic
Thread Starter
I was to cheap at the time to buy any upgraded suspension or drivetrain so I never could launch at a high enough rpm to get right into boostbasically the turbo would not spool till 330' at least. Martin @ Tick was there he can vouch I back half in the 1/8 nearly a 104mph. 8.0 on time lol lol. I tried leaving at 3300rpm with a 2step and broke driver axle. Parked it and started the rebuild of entire car. Link to new build in sigs above. Signature does not show up when I'm posting from mobile like this