97 Camaro LS1(346) 76MM Turbo Build Thread
#459
8 Second Club
Thread Starter
iTrader: (12)
Join Date: Nov 2010
Location: Durham
Posts: 747
Likes: 0
Received 0 Likes
on
0 Posts
97 Camaro LS1(346) 76MM Turbo Build Thread
After running into a cracked head issue, then pushrod clearance problems, I have finally made some headway and finally got the car started again.
The last thing I really needed to do was center the rear and weld up the anti roll. It will be going to the chassis shop soon to make sure everything is right.
Anti roll getting final welds by David at BoostFab
The plan right now is to hit the dyno tomorrow and if all goes well the chassis shop to get set up and scaled, then the track
The last thing I really needed to do was center the rear and weld up the anti roll. It will be going to the chassis shop soon to make sure everything is right.
Anti roll getting final welds by David at BoostFab
The plan right now is to hit the dyno tomorrow and if all goes well the chassis shop to get set up and scaled, then the track
Last edited by THADD; 07-28-2015 at 09:47 AM.