randomninels1nova

Columbia River

randomninels1nova

Hey guys looking for a reducer from 5 to 4 inch in stainless any leads would be great thanks

LilJohn

measure out 3.14 inches on the circumference of the pipe and mark it.... mark a point halfway between those two points and draw a line down the side of the pipe stop your line about .100-.150 thou shy of the end of the pipe.... cut out a triangle shaped pie cut from the pipe using the 2 points that are 3.14 inches apart on the one end to the end of the line you drew on the side of the pipe... Put a couple tbolt or worm clamps around the pipe and tighten until the edges touch... prep and weld the seam....

You just made your own 5 inch to 4 inch reducer.

a98ws6

iTrader: (48)

Race Parts Solutions makes one i believe.

randomninels1nova

I shall try that, save me some money haha

98Camarod

iTrader: (43)

nice work. What are the goals?

randomninels1nova

Honestly I'd be happy getting into the 9s anything deeper would be a plus

randomninels1nova

So not really a good update, I am at square one with the wastegates, I was sold knockoffs by a member on here that has not been on ever since... won't respond to any of my calls, text, or pms so I'm SOL for now... I guess I'm too trusting....lesson learned that's forsure..

a98ws6

iTrader: (48)

Who sold you the gates? Can PM me if you'd rather not post.

randomninels1nova

Brandonk