3 BAR MAP LS6 intake
3 BAR MAP LS6 intake I bought the ZR1 3 BAR MAP (pn: 12592525) and just realized that the connector is different than the male connector on my LS1 harness (04 GTO). Is my only option here to buy the expensive Lingenfelter adapter harness?
I could drill and tap the hole and put a NPT fitting with a barb in it but I'd rather not. And I'd still have to do something about the electrical connectors being different types and not fitting. If I can find a plug and play 3 BAR I'd rather just return this one.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
9 Second Club
Joined: Jun 2013
Posts: 271
Likes: 0
9 Second Club
Joined: Jun 2013
Posts: 271
Likes: 0
Yeah good point... figured it would be too good to be true. Thinking it over, I will probably just tap the rear MAP hole and put a fitting on it to to run this ZR1 MAP. I just hate to have to spend $30 on a harness adapter to make it work. The fitting I could care less about because I already have some quick fit fittings that will work.
As long as your getting the right liner offset for the map then your good. Personally I buy mine from dsteck which makes them himself I'm sure others work well also just get the data
I calculated them from the transfer function. I am not convinced that calculation gives the correct offset.
Anyway, I'm using mine anyway.
So if anyone has Dsteck's sensor and would care to share those numbers with me in private, I'd like a sanity check of my values. I used the same Freescale 3 bar sensor he uses.
Ron