Turbo headers
the problem of putting the turbo on the side of the engine is you are limited to how big of a turbo you could use.
who needs abs?
id like to see the twins come to the front of the engine so you could stuff a couple of 60 series turbos there.
yummy.
who needs abs?
id like to see the twins come to the front of the engine so you could stuff a couple of 60 series turbos there.
yummy.
Originally Posted by Project GatTagO
That is a Wagner Automotive Research intake. I am sure it will be plumbed for EFI. Notice the cast-in injector bungs.
Andrew
Andrew
That car is going to be fast
Thread Starter
FormerVendor
iTrader: (33)
Joined: Feb 2002
Posts: 5,052
Likes: 0
From: Lake in the Hills, IL
That is a GM carb intake for the LS1. Wagner did the development for them. It will be plummed for EFI w/our fuel rails and all. It is Christies car we are using to mock up the headers on her car will be a monster twin turbo and it will be insane fast.
Thanks Nate
Thanks Nate
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
So if I ditched my power steering and went to a manual rack it looks like I would still lose AC. Is there a smaller compressor that we could use that could get mounted somewhere else? It's looking more and more like a single kit might be in my future instead of twins 
Also, would the WAR intake fit under an SS hood with a 90* bend on top? It doesn't look like it would...
Thanks,
Also, would the WAR intake fit under an SS hood with a 90* bend on top? It doesn't look like it would...
Thanks,
Thread Starter
FormerVendor
iTrader: (33)
Joined: Feb 2002
Posts: 5,052
Likes: 0
From: Lake in the Hills, IL
PSJ it is high above the rack. The last tube is fairly close to the steering shaft but should clear. This is the second set we have made because of clearance issues.
Scott you could keep the A/C no problem just would need to route the down pipe elsewhere. It is just perfect right where the A/C compressor is. And the intake does not fit without some hacking on the cowl and a tall hood.
Nate
Scott you could keep the A/C no problem just would need to route the down pipe elsewhere. It is just perfect right where the A/C compressor is. And the intake does not fit without some hacking on the cowl and a tall hood.
Nate
