OLD 10.5 mustang to no prep terror street car
#204
TECH Enthusiast
Thread Starter
#206
TECH Enthusiast
Thread Starter
#208
TECH Enthusiast
Thread Starter
Well, went to pick the car up today. Got an flat that Larry helped me with. CSR turned out nice. Everything flows well under the hood and isn't crammed together. Now wiring carpet, paint.
It was actually like NASCAR. With my floor jack and cordless impact, i had the tire off in 2 minutes.
Here it is looking for a ride home.
Definately have to get a new trailer. This old tilt has been good to me, but the car is too low for it.
Without the wheelie bar cutout, there is no way I could have reachecd the tabs to strap it down.
It was actually like NASCAR. With my floor jack and cordless impact, i had the tire off in 2 minutes.
Here it is looking for a ride home.
Definately have to get a new trailer. This old tilt has been good to me, but the car is too low for it.
Without the wheelie bar cutout, there is no way I could have reachecd the tabs to strap it down.
#210
TECH Enthusiast
Thread Starter
#212
TECH Enthusiast
Thread Starter
#213
TECH Enthusiast
Thread Starter
Got some race Jack's for the car to make it easier to work on at the track and shop. Missing one freaking fitting. Maybe I CAN GET IT UP BY THE WEEKEND. Going to start removing stuff for coating midweek so we can keep moving forward.
Got all the electronics spread out on the table double checking on sensors etc. Wiring is super intimidating for me so I will mount etc but probably leave it for someone else so I can get this done by March.
Got all the electronics spread out on the table double checking on sensors etc. Wiring is super intimidating for me so I will mount etc but probably leave it for someone else so I can get this done by March.
#215
TECH Enthusiast
Thread Starter
#218
TECH Enthusiast
Thread Starter
Motor is ready to pull. Got the motions race works valley cover plate. Hopefully it will have the motor out tomorriw. Repaint cage and front bars 2nd week of December. Then wiring and carpet. Mid to late January exterior paint. Not sure on color yet.
Last edited by MIAmotorsports; 12-01-2018 at 06:25 PM.
#219
TECH Enthusiast
Thread Starter
Starting to get some parts back from coating. Front plate and midplate is all that's left for coating. Turbo polishing and brackets still not back from polishing
Not going to tear down rear suspension. Until it is done.
Ceramic coated the fan shroud to so I couldn't polish.
#220
TECH Enthusiast
Thread Starter
Hinged flip down electronics panel done. Cant tell by the pic but it is hidden nicely behind the dash.
Now I got to take everything apart for paint. It sucks because of the hrs to put the stuff in.