APE Shop Car Getting Closer
TECH Resident
Joined: Jan 2002
Posts: 956
Likes: 0
From: Phoenix, AZ
No problem Chris. I can't wait to see what it will do myself. What would you estimate it will do on motor alone, 91 octane? My guess ( or hope! ) is around 375rwhp. I figure 650 should be within reach by adding in the alky.
- Dug
- Dug
Chris, I know you all said it was a custom peice, but how hard was it to fab up the gauge cluster for the A/C area?? I have some ideas I saw used in a 94 Mustang that they molded a Autometer gauge cluster to it all.. Am I going along the same lines is you all did, if thats what I plan on doing.. I love the setup!
Originally Posted by Mr Powell
Chris, I know you all said it was a custom peice, but how hard was it to fab up the gauge cluster for the A/C area?? I have some ideas I saw used in a 94 Mustang that they molded a Autometer gauge cluster to it all.. Am I going along the same lines is you all did, if thats what I plan on doing.. I love the setup!
Thanks,
You got it... APE has the best customer service...... Chris my cell is on me give me a call when you get a sec away from your hectic schedule.... Breath man.....
Kyle
Kyle
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Originally Posted by Mr Powell
Chris, I know you all said it was a custom peice, but how hard was it to fab up the gauge cluster for the A/C area?? I have some ideas I saw used in a 94 Mustang that they molded a Autometer gauge cluster to it all.. Am I going along the same lines is you all did, if thats what I plan on doing.. I love the setup!
I used autometer bezel's and plastic welded a grained ABS sheet to the back. There is a fair amount of trimming and stuff but with the right tools and patience it can be easily diplicated.
Tom
Originally Posted by FSTR-THANU
I used autometer bezel's and plastic welded a grained ABS sheet to the back. There is a fair amount of trimming and stuff but with the right tools and patience it can be easily diplicated.
Tom
Tom
That's right from the guy's who made them for me!!
