SDWYZ C5

My 1st Stage Project is now complete .

Here is what I did.... My new found power!!!

All Installs By ME!!! (with a few buddies and )
All installs went smooth! No Problems at all!!!

Dyno = 531RWHP 488RWTQ and loving it.

I\C Maggie Kit w\3.1 Pully, Custom Grind Cam, Julio's (ECS) Alky Kit, Harland Sharp Roller Rockers, Rev Double Springs, Titanium Retainers, Hardened Locks and Seats, Double Roller Timing Chain, 7955 PushRods, Upgraded Oil Pump, Walbro Fuel Pump, Dynatech SuperMaxx LT Header System, Corsa Pace Car TigerShark Edition Exhaust, Blackwing, TR6 Plugs, MSD Wires, AutoMeter Gauges

Next, Stage 2. Prep for the track.
Clutch, Output Shaft, DR's...

Can't wait to see track times...

30th t/a

iTrader: (51)

wow thats awesome. i bet that car plants you into the seat bigtime...if you dont blow the tires off! congrats. i cant wait to see you times. what tires are you going to running?

SDWYZ C5

I have seen 8.8lbs of boost on the dyno. With a 3.1 pully, I did not think I was going to see 8.8lbs but I am liking it.

Stock heads and stock compression. The Dyno Numbers are achieved with a safe tune too. O2 readings where taken before the cats.

Rick from Synergy did the tune. He has been tuning the LS1's for years now. He just got his new dyno just a couple of weeks ago and it is amazing. He is able to control the axle speed and hold it while tuning in each part open throttle segment more accurately. Not to mention he did a great job at WOT too.
Rick is also experienced with Alky. Rick does a great job.

I hear both Nick @ Newtech or Rick @ Synergy are the best around here in the Bay Area.

Blackbird

Sweet!

Yes that dynapak rocks the house hands down.

Don't you love how he can make changes real time and you see whether it's making or loosing power at any given rpm / load.

Got Me SOM

iTrader: (2)

Nice Numbers And The Best Of Thing Is You Have A Lot Of Torque Down Low.