Ari G

iTrader: (25)

What Blocks are you using with those high hp

Can the aluminium stock block handle 1100hp or the truck Cast block?

y2khawk

iTrader: (5)

yes and yes

nitrorocket

iTrader: (12)

I run aluminum, 800+ rwhp.

Ari G

iTrader: (25)

Say with the aluminium block,isin´t it easy to warp them if the mis heat?especially with high boost

nitrorocket

iTrader: (12)

I run 18.5 psi in a street car with 93 octane, the car runs at 200 all the time, no problems here!!!

cws T/A

iTrader: (3)

Ive never seen a crooked aluminum block .Aluminum doesn't bend it breaks. IF its bent its probably melted and cooled to that shape. I figure your refering to the stock cylinder sleeves Get some thicker sleeves DARTON has some like the ricer hondas do to make the block survive . Im thinking not many blow because off to much power, unless your John Force their will always be a culprit inproper tune.. leanspike .. not enough fuel retard at the wheel ...John Force etc.