Good pic of truck manifold setup with K-member notched?
#1
TECH Fanatic
Thread Starter
iTrader: (35)
Join Date: Sep 2004
Location: Maryland/Illinois
Posts: 1,660
Likes: 0
Received 0 Likes
on
0 Posts
Good pic of truck manifold setup with K-member notched?
Anybody have a good picture of the notching that needs to be done to the stock K-member on a truck manifold turbo setup? I looked thru the sticky but most of those fellas have an aftermarket k-member.
#2
TECH Enthusiast
iTrader: (22)
Originally Posted by bowtieman81
Anybody have a good picture of the notching that needs to be done to the stock K-member on a truck manifold turbo setup? I looked thru the sticky but most of those fellas have an aftermarket k-member.
Trending Topics
#8
TECH Addict
iTrader: (8)
I kinda notched mine to make some more clearance. Just from looking at it. I also took about an inch off the inside of the motor out stand. Heres some pics of my k-member.... hopefully it will work. I also took about 3/4" off the edge. I just basically made a few cuts and scribes, and then beat it down flat and then welded all the seams. I wont know if its sufficient till i get the engine back in.