Cannot get Procharger Belt on....Help
Cannot get Procharger Belt on....Help Any tricks to get belt on? I have 6-rib d1sc w/ 3.4" blower pulley.....Called procharger and they gave me part # K060355 which is 36 1/8" long......they only way I can get it on is if there is only one bolt holding head unit on and the tension pulley is removed.....I also got one size up which is part # K060365 and is 37 1/8" long and goes on with no problem but needs the tension pully all the way down and is still not as tight as it needs to be.......any suggestions or know where online I can order a belt that is imbetween the two above...? Thanks
did you have to use a screwdriver and pry at it? With the smaller belt if I leave the tensioner on I can't get it on....(it is all the way up).....If I dont get it tom...I will post some pics because this seems alot harder than it should be
leave the ten. all the way up and then put the belt on the pulley, u may have to tilt the blower a lil bit, but once the belt is on push the head unit up and start putting you bolts in, you will be amazed at how far the ten. pulley goes down once you adjust it. keep with you'll get it.
Originally Posted by blownws6_nc
once the belt is on push the head unit up and start putting you bolts in
.....if that is what you mean I havn't tried that and hopefully it will work tom
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
8 sec potential, 12 sec slip
iTrader: (50)
Joined: Apr 2002
Posts: 4,092
Likes: 2
From: Savannah, GA
I have to take the crank pulley off mine, put the belt on, then rotate the crank pulley back up into place and bolt it back on. But I have an 8 rib, so it may not be as easy for a 6 rib. I don't remember how the 6 rib pulley bolts on? 