camaroandreas

Anyone tested it with 1200hp and 7000 rpm?

MIGHTYMOUSE

iTrader: (59)

i am something like that, my limiter is at 7200 though i normally shift out around 65

earlier this season i was running out on the limiter before shifting to OD like i do now

camaroandreas

Sounds good, it´s a LQ9 stock crank..

y2khawk

iTrader: (5)

most of the stock cranks are the same casting, sans LS7, with different final machining.

As for power level, been there done that. Many have

Personally, i shifted mine about 8k RPM with power around 1400 crank HP.

Speed

iTrader: (33)

just to confirm, this was on a stock crank?

y2khawk

iTrader: (5)

yes, like 3 or 4 years ago

171 MPH at ~3300 LBS

Speed

iTrader: (33)

I knew you had a hot setup, just didn't know much about it. Makes me feel a lot better about my measly 800hp goals.

NA$TY-TA

iTrader: (21)

same here. Stock crank and 1100rwhp spinning to about 7K. Where ever Y2KHawk set the rev lim LOL.

Kyle

camaroandreas

Sounds great, thanks !

I will post a thread soon on my Camaro -69 build with a Bullseyepower S480

TwnTrboCE

iTrader: (43)

Stock LS1 crank- 8.50's @ 170 @ 3700lbs, shifting at 7800.

Stock LS7 crank- 7.91 @ 177 @ 3450lbs, shifting at 7400...So far

LS1RedZ

iTrader: (19)

Damn that makes me feel better!!

y2khawk

iTrader: (5)

i guess you're the crazy ****** now

Speed

iTrader: (33)

I think you are all crazy *******!


I'm a fan

y2khawk

iTrader: (5)

you ain't seen nothin yet

DanZ28

iTrader: (5)

Kyle, ddi you mention somewhere about yours starting to flex? I' don't know, I've read so much I don't know who did what anymore, lol.

Dan

cbra-klla

iTrader: (52)

why does anyone even bother with aftermarkert cranks then???

Andy02Z

iTrader: (1)

Stroker, peace of mind.

67Firebird455

iTrader: (27)

To increase stroke from 3.622.

NA$TY-TA

iTrader: (21)

My stocker was reused in 3 motors and in the 2nd to the last it was scored some. Harlan can atest to that. He pulled the mains last time. When the motor was rebuilt the crank needed I be cut some and I'm not sure ifnit was nitrated again and if that made it weaker. Not sure. All I know is it was flexing. I was stillnusing stock main caps. This time they will be billit main caps and a forged crank more for cubes then anything. I'd use one and not be scared.

Kyle

Oh yeah. Show off Mike.

Wonderbread

iTrader: (51)

From what I hear and have experienced the 5.7 cranks have hollow rod journals and are a little harder to balance without adding mallory metal. The 6.0 Cranks have solid rod journals and can be drilled for balancing purposes. This is all assuming after market rods and pistons and I guess can depend on the bob weight.

Im not doubting any of you guys, the numbers you put up speak for themselves and are insane!! . Just figured I would throw my .02 in.