700 rwhp goal?
#1
Thread Starter
10 Second Club
iTrader: (13)
Joined: Feb 2006
Posts: 3,297
Likes: 0
From: MOREHEAD KY
700 rwhp goal?
hay folks what are you doing to get 700 rwhp on pump gas?? i want to see how much farther i have to go?? last time i dynoed the car it was a 500 hp at 6.5 psi i will be getting a d1 and making more boost and getting a new tune, i just want to make sure im not setting my goals to high, thanks for any help
Ricky
Ricky
Trending Topics
#9
Not trying to Hijack or anything.... but from what I gather with a built 402 or 408, and lets say an F1A, on pump gas with out meth. It's possible to make around 800+? and at what boost would we be looking at?
#11
Ricky be conservative with timing since you are not running meth and are running 9.8:1 compression based on your other posts.
I'm running 19/20 degrees of timing at WOT but I'm 8:1.
I'm running 19/20 degrees of timing at WOT but I'm 8:1.
#12
It's all in the tune... Serious... and mine has 30,000 miles all above 620rwhp and up to the current level... a good tuner, and you're in there for sure with your setup...
#17
The larger cubes you go the more power your going to make off boost and if your compression ratio is set up right (say between 8.5-9:1) with a good set of heads then 800 rwhp can be done on pump gas. You will just need a real good tune. I would say a forged 408 iron block with AFR 225's/TFS 235's/ETP 235's and an F1A pushing 16-17psi or so you would be in that realm.
#19
#20
Thread Starter
10 Second Club
iTrader: (13)
Joined: Feb 2006
Posts: 3,297
Likes: 0
From: MOREHEAD KY
The larger cubes you go the more power your going to make off boost and if your compression ratio is set up right (say between 8.5-9:1) with a good set of heads then 800 rwhp can be done on pump gas. You will just need a real good tune. I would say a forged 408 iron block with AFR 225's/TFS 235's/ETP 235's and an F1A pushing 16-17psi or so you would be in that realm.