Got twist? Moser 35 spline axles
07-23-2010, 06:21 AM
#23
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
Not to stir up anything, but with that much HP/Tq and the ET you ran in a heavy (3500lb) car, you should probably be running a 40 spline axle to begin with...Call Moser, they will replace that axle for free providing it's under 10yrs old, and you have proof of where you bought it. Good luck and nice ride for sure LOL
I'm willing to bet that my replacement strange axles will not have any issues...I trust MADMAN's opinion and he said I'll be fine. If he recommended that I step up to 40s then I would have...but that requires alot more part changes...
07-25-2010, 10:21 PM
#26
Banned
iTrader: (4)
Join Date: Oct 2009
Location: Bowling Green
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Like I said I wasn't trying to tick you off, but that is alot of stress on a 35 spline setup...Good luck to you on your future runs. Don't forget to send the axle to Moser....You can always get it replaced, then sell them.....
07-26-2010, 09:07 PM
#29
Staging Lane
iTrader: (1)
Join Date: Jun 2009
Location: swansboro NC
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
is that dexron 3 fluid your using, looks like it on the axle, whats the benefit of using it ( if you are that is ) and is it street able ( with in reason for a street strip car )
07-26-2010, 09:21 PM
#30
Banned
iTrader: (4)
Join Date: Oct 2009
Location: Bowling Green
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Can't say what fluid he's running, but I know of some Pure Street mustang guys running one quart of 75w140 gear oil then topping off the rear with 5w30 engine oil....Less friction means quicker runs.....I don't know how well that holds up under street use though...
1.33-1.36
08-10-2010, 07:49 AM
#34
TECH Senior Member
Thread Starter
iTrader: (21)
Join Date: Nov 2001
Location: Cecil County Raceway!!!
Posts: 8,484
Likes: 0
Received 0 Likes
on
0 Posts
new strange axles arrived
The pocket milling looks awesome
the pair (including wheel studs and bearings) are 6lbs lighter than the old mosers.
The pocket milling looks awesome
the pair (including wheel studs and bearings) are 6lbs lighter than the old mosers.
03-25-2012, 05:16 PM
#37
12 Second Club
iTrader: (1)
Join Date: Jan 2004
Location: Iowa
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
I had a Strange 12 bolt and the axles twisted about half a spline. They told me that its normal and would be fine until I had one full spline of twist. It only had 375a rwhp.
