01transampower

iTrader: (9)

Well tonight i went to the track and was playing with my launches after all the motor work i had done over the winter. It was my 4th run of the night and got in a good burn out and decided to see what my car would do at a 4700-5000 rpm launch. Needless to say with the sticky tires and the new monster stage 2 clutch i blew the drive shaft into 3 pieces. One piece was still hooked to the rear-end one to the the trans and a third small piece shotoff under the car. Sounded so much worse with the noise an all in person lol. So my question is what driveshaft do you guys use? All my mods are in my sig so what would be your best guess for one. Thanks

01ssreda4

iTrader: (96)

Go with a PST from Brute Speed.

02chickenhawk

I got one from Strange.

I have an aluminum one sitting in my garage if interested since your 68 miles north of my location.

BlackScreaminMachine

iTrader: (17)

3" "Nitrous Ready" Steel unit from Denny's

5-6k Clutch dump on a heavy *** car that picks up the wheels and still driving great!

01transampower

iTrader: (9)

Thanks for the offer on the stocker but I don't want this to happen again lol. Just buy a new that's rated. Ill have to look into them all tonight and order one. Should I get a hold of Bob from brute speed if I go that way?

02chickenhawk

Bob or Carl can take care of you. They are around 304.00 for the Strange driveshaft.

ssvert99

iTrader: (26)

I have driveshafts from PST and Strange, with any option you want, and the guaranteed best price. Give us a call!

01transampower

iTrader: (9)

Thanks for the help guys i want to order one as soon as possible to get my car back up and running.

01transampower

iTrader: (9)

Another question I didn't check the other night but are the stock M6's a slip yoke or are they just double yoked? one on each side?

masnart2000

PMed you.

Bob@BruteSpeed

iTrader: (16)

Thanks, I appreciate it! Bob