Driveshaft length: T56 w/viper tail to 9"
#1
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: Newberg Oregon
Posts: 371
Likes: 0
Received 0 Likes
on
0 Posts
Driveshaft length: T56 w/viper tail to 9"
I am slowly getting my car back together, I had my trans rebuilt with a 31 spline viper tail shaft. I also have a qp 9" in rear end. I already have the yoke so I am just going to order a Driveshaft from pst but I need the length. Thank you guys
#2
LS1Tech Sponsor
iTrader: (16)
PST goes off the dimension from the back of the tailshaft to the centerline of the rear yoke. if you already have the 9 inch rear in the car, take the dimension with the car in the loaded (drive) position. I have the schematic at the link here, it will be the "x" dimension. http://shop.brutespeed.com/PST-DRA35...-PST-DRA35.htm You can then give them this dimension along with the spec's on your yoke. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website