JimMueller

iTrader: (9)

I'm researching the possibility of adding aftermarket TCS to my car. The solution needs active sensors and reluctor wheels at all four wheels. Other than the additional cost, are there any gotchas with running TCS axles (with the reluctor ring) on a car that didn't come with TCS from the factory? If not, does anyone know where I can find the OD of the ring and the tooth count to compare it to the proposed front solution (2009+ C6 wheel bearings)?

JimMueller

iTrader: (9)

Bump!

FirstYrLS1Z

iTrader: (4)

4 channel axles w/rings can be installed/run in a 3 channel rear without problems.

JimMueller

iTrader: (9)

Thanks! So... buy new oem 4ch axles with reluctor pre-installed. When the 3ch axles are swapped for 4ch, what can be tidied up from the OEM design? Remove the old sensor on top of the diff and seal the hole? How about inside the case?