Anyone running Moser Billet Aluminum yoke?
03-15-2003 | 07:48 PM
#1
Thread Starter
TECH Fanatic
iTrader: (23)
Joined: Feb 2002
Posts: 1,011
Likes: 0
From: Ft. Worth, TX
Anyone running Moser Billet Aluminum yoke? I plan on using it with a 1" shorter than stock Denny's MolyMatrix(I think that's what they call it) driveshaft.
Any opinions/comments are appreciated.
Thanks,
Wes
Any opinions/comments are appreciated.
Thanks,
Wes
03-16-2003 | 03:29 PM
#4
Thread Starter
TECH Fanatic
iTrader: (23)
Joined: Feb 2002
Posts: 1,011
Likes: 0
From: Ft. Worth, TX
Re: Anyone running Moser Billet Aluminum yoke? Cool, I thought the shaft had to be an inch longer or else there would be tailshaft/driveshaft issues.
I haven't seen the yokes side by side, but the billet yoke is exactly 1" longer than the steel, am I correct MIGHTYMOUSE?
I haven't seen the yokes side by side, but the billet yoke is exactly 1" longer than the steel, am I correct MIGHTYMOUSE?
