View Poll Results: When should I put the bolt-ons on?
Voters: 42. You may not vote on this poll
Finally got LT's, ORY, and an LS6 intake, install now or middle of summer?
03-19-2010, 03:34 PM
#24
Ordered some parts today.
Edelbrock O2 extentions.... $25 for both
Header gaskets (dont remember brand, maybe Mr. Gasket?) $20
Felpro Intake gaskets $25
Do these seem like good prices?
Where can I get some poly engine mounts? I also made about 10 or so block off plates for the headers. 18-22 guage should be ok right?
Should be pulling it out tuesday evening to start working on it
Edelbrock O2 extentions.... $25 for both
Header gaskets (dont remember brand, maybe Mr. Gasket?) $20
Felpro Intake gaskets $25
Do these seem like good prices?
Where can I get some poly engine mounts? I also made about 10 or so block off plates for the headers. 18-22 guage should be ok right?
Should be pulling it out tuesday evening to start working on it
03-22-2010, 07:20 PM
#26
I am bringing the car home tomorrow.
I have to get different o2 extensions because he thought I was getting them for my 93
... Not that it really matters cause when I went to pick up the parts I told him they were wrong so I didn't really waste time... I think I will end up ordering some from Texas speed... They have the cheapest so far at $20 each for 19".
As for engine mounts I bought some brand new poly mounts and poly torque arm mount for 35 bucks shipped off a local forum
For the rear o2's can I just unplug them or tape them off until I get the car tuned? I don't want to spend 100 bucks on sims that is crazy. I won't effect anything if I disconnect them or tape them off for a month will it? Other than throw a code?
Thanks!!!
I have to get different o2 extensions because he thought I was getting them for my 93
... Not that it really matters cause when I went to pick up the parts I told him they were wrong so I didn't really waste time... I think I will end up ordering some from Texas speed... They have the cheapest so far at $20 each for 19".As for engine mounts I bought some brand new poly mounts and poly torque arm mount for 35 bucks shipped off a local forum
For the rear o2's can I just unplug them or tape them off until I get the car tuned? I don't want to spend 100 bucks on sims that is crazy. I won't effect anything if I disconnect them or tape them off for a month will it? Other than throw a code?
Thanks!!!
