Building a car
06-27-2010, 02:01 AM
#1
TECH Apprentice
Thread Starter
iTrader: (3)
Join Date: Feb 2010
Posts: 373
Likes: 0
Received 0 Likes
on
0 Posts
Building a car Hi, how's everyone doing?
I am planning on building my car, the budget is around 30K, including:
buying/building the transmission (T56)
9" rearend
Engine
Turbo's
I was planning a 400+ cube LSx that is either single or twin turbo'ed and was wondering if anyone can help me out.
The car will first be N/A, then eventually (within a couple years) turbo'ed VIA Modular Turbo's new F body kit.
I know that the engine will be forged, but do not know how to figure out the CR. also, what is a good CR range for an 16+ PSI boost? knowing this will help me figure out what heads/pistons I need.
also I want to know what engine builder would help me throughout the entire process, even after the engine is done and about to be turbo'ed.
I am planning on building my car, the budget is around 30K, including:
buying/building the transmission (T56)
9" rearend
Engine
Turbo's
I was planning a 400+ cube LSx that is either single or twin turbo'ed and was wondering if anyone can help me out.
The car will first be N/A, then eventually (within a couple years) turbo'ed VIA Modular Turbo's new F body kit.
I know that the engine will be forged, but do not know how to figure out the CR. also, what is a good CR range for an 16+ PSI boost? knowing this will help me figure out what heads/pistons I need.
also I want to know what engine builder would help me throughout the entire process, even after the engine is done and about to be turbo'ed.
Last edited by battousai; 06-27-2010 at 02:27 AM.
